Shopping cart: 0 item £0.00
The Veba AVRS range are flush mounting sensors. The AVRS7 is a 4 recess sensor high quality system that will cover the widest of cars giving a professional OEM finish. Included with the 4 recess sensors is a buzzer giving audible bleeps with increasing frequency as you get closer to an obstacle and a mini colour camera that also mounts flush inside your bumper. This is supplied with cabling to connect to the TFT monitor.
Four bumper fit sensors
The system works by radiating ultrasonic beams covering the area behind the vehicle. The beams are reflected by obstructions behind the vehicle, and re-enter the sensors. The reflected beam information is processed to calculate the distance of the obstruction.
As with the other systems the Veba's are activated when reverse gear is engaged. As the vehicle is reversed. When the vehicle is less than 1.5 metres from the obstruction the audible alert will emit intermittent bleeps. As the vehicle gets closer to the obstruction the display indicates the reduction in distance and the frequency of the bleeps increases. At 45 centimetres from the obstruction the bleeps become a continuous solid tone.
The Veba recess systems can also be attached to the front of a vehicle for all-round protection. In this instance the power lead needs to be wired into the fuse box rather than the reversing light so that power is always on when the car is in ignition. We suggest the fuse for the car stereo or interior lights.
Rated Voltage (range) - 12V(10.5V~16V DC)
Rated Current - 200mA~600mA
Detection Distance - 0.2m~1.5m
Camera Viewing Angle - 900
Sensor Frequency - 40KHz
Working Temperature of ontrol Box - -30~+80
|Some Useful Measurement Information |
(measurements are approximate and not guaranteed)
|Component||Length x Width x Depth|
|Size of Control Box||12 x 9.4 x 2.7cm|
|Size of Speaker||7.4 x 5 x 2cm|
|Size of Ultrasonic Recess Sensors||21mm Dia. 20mm deep|
|Size of Camera||25mm Dia. 40mm deep|
|Size of Screen||26 x 8.6 x 2.5|
|Diameter Size For Sensor Drilling||21mm (Drill Bit Supplied)|
|Diameter Size For Camera Drilling||25mm (Drill Bit Supplied)|
|Length of Speaker Cable||5m|
|Length of Sensors Cabling||2.5m|
No routine maintenance or adjustment is required. Dirt, frost or snow accumulated on the sensors may cause the system to activate incorrectly. Clean carefully with a soft cloth. Do not use chemicals or spirits. Applying hot water in frozen conditions may damage the sensors. The sensors can be washed carefully with warm soapy water.